This page is intended for one of our RepRap implementations - Prusa Mendel.
Check out our event-log for Teh Prusa
Full partlist: http://reprap.org/wiki/Prusa#Non-Printed_Parts_.28.22vitamins.22.29
Visual instructions: http://garyhodgson.com/reprap/prusa-mendel-visual-instructions/
Flickr assembly walkthrough: https://picasaweb.google.com/bokowski/PrusaMendel#
MK7 stepperstruder was substituted in for the old DC motor struder. -Zarutian
Makerbot í láni frá Dóra (Makerbot on loan from Dóri)
Hitaplötu tenging við aðalstjórnborð:
http://arduino.cc/en/Hacking/PinMapping2560
http://makerbot.wikidot.com/thingomatic-doc:makerbot-motherboard-2-4
Port L pinni 4 getur verið góður candidat fyrir PWM út fyrir hita stýringu
-Zarutian
===Current shopping lists: ===
Innkaup
Pennar filt /kúlu
*Nál / tvinni
*límband / ductape
*demmel cutter
*coathangers
'''plywood 10 mm thick''' for the Platform
====Makerbot store: ====
*2x pack of 8 skate bearings
*3x stepper motor driver
*1x Mechanical endstop kit
*4x Nema17 steppers
====Digikey: ====
*adf
====Pololu====
*1 cheap Nema17 spare
*Lots of header connectors and pins
*Pin crimper
Mc Master
*http://www.mcmaster.com/
*Belts and sprockets after Joe examines them
===Parts we need===
*Molex 09-50-3041 connectors (a bunch, at least 10)
*Molex 08-52-0072 connector crimp pin (a whole bunch, maybe 100)
*Cable splitter for stepper control signal
*Ribbon cable
*Belts (T5 pitch 5 mm wide, at least 3 meters in length)
*Timing belt pulleys
*Breadboard male pin crimping connectors
===Parts we might want===
*Pillow block slider bearings
*Normal bushing bearings
===Parts Joe will be getting===
Anti Static Mat(s)
*Label Printer
*4x Nema 17 Stepper motors ( http://www.sparkfun.com/products/9238 )
*Stacking headers for Arduino shields ( trial one of SAM1202-06-ND - get more from Ada)
*Molex C-grid SLs
===Parts that we are getting from Makerbot (Gummi)===
*2x 8 pack of 8mm ID, 22mm OD and are 7mm thick. 608 type bearings for $5 each.
*3x Stepper Motor Driver v3.3 for $39 each
*1x Mechanical Endstop v1.2 (Set of 3) for $30
Updated by Joseph Foley over 9 years ago · 1 revisions